Installation Sheet

S2650

ASSEMBLY & INSTALLATION GUIDE

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT

BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR

OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Remove mounting plate (A) from ﬁxture base (C) by unscrewing base screws (D).

2. Attach mounting plate (A) to wall outlet box and secure with mounting screws (B).

3. Attach ground (green) wire to ground wire from wall outlet box (usually green or copper in color), fasten together with

a plastic wire connector. Tightly wrap the wire connector with electrical tape so the end of the connector is sealed. IT

IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.

4. Connect neutral (white) future wire coming from future base to neutral (usually white) outlet wire. Fasten both wires

together with a plastic wire connector and tightly wrap the wire connector with electrical tape.

5. Repeat the procedure with the hot (black) wires. Always make sure that no wire strands are left outside the

connectors. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL BE

COMPROMISED.

6. Attach future base (C) onto the afﬁxed mounting plate (A) and secure with base screws (D).

7. Screw the center ring of shade (H) onto the top of lamp holder (G) in clockwise direction.

8. Insert light bulb into socket.