Installation Sheet

ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Carefully place acrylic diffuse (M) and shade (L) on shade rim (N). Attach
shade support bars (K) to the shade rim (N) and secure by inserting screws (0)
to the holes.
2. Hook the shade support bars (K) onto the cut-out sections of cross part (J).
3. Attach chain (G) to top loop (H) on light fixture.
4. Feed wire through chain (G) and chain mounting loop (D).
5. Slide canopy (E) and canopy ring (F) on chain (G).
6. Attach mounting strap (A) to ceiling outlet box and secure with mounting
screws (B). Insert top thread nipple (C) in mounting strap (A).
7. Attach chain mounting loop (D) to thread nipple (C).
8. Attach chain (G) with fixture to chain mounting loop (D) at desired height.
9. Attach the ground wire (bare wire) from the fixture to the ground junction
box wire (usually green or copper wire). Fasten together with a plastic wire
connector and wrap the connection with electrical tape. Be sure no wire
strands are exposed.
10. Connect the neutral wire from the fixture (ridges molded wire) to the neutral
wire from the junction box (usually white). Fasten together with a plastic wire
connector and wrap the connection with electrical tape. Be sure no wire
strands are exposed.
11. Connect the hot wire from the fixture (smooth wire) to the hot wire (usually
black) from the junction box. Fasten each together with a plastic wire
connector and wrap the connection with electrical type. Be sure that no wire
strands are exposed.
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS
OTHERWISE SAFETY WILL BE COMPROMISED.
DRY
Aspen Large Conical Pendant
Item # S5033