Installation Sheet
1. Carefully remove all parts from the box.
2. Remove the mounting plate (B) from the canopy (E) by unscrewing the collar ring (F).
3. Install the mounting plate (B) and collar loop (D) to the junction box with mounting
screws (C) provided. Using a wrench (not provided) secure the mounting plate (B) and
collar loop (D) to the threaded nipple using provided hex nuts.
4. Install the canopy (E) to collar loop (D) and secure with collar ring (F). If needed, adjust
canopy (E) height by loosening hex nuts and screwing collar loop (D) up or down then
re-secure.
5. Remove the metal bars (M) from the fixture frame (L) by unscrewing the screws (N).
6. Attach the glass panels (J & K) to the fixture frame (L) and secure using the metal bars (M)
and screws (N).
DO NOT OVER-TIGHTEN SCREWS, OTHERWISE GLASS COULD BECOME DAMAGED.
7. Hang the fixture cluster hook (O) to the ring (P), then run the fixture wires through the hole
of the fixture loop (I).
8. Feed wires through the rod (H), rod (G).
9. Hang the rod (H) to fixture loop (I), then hang the rod (G) to fixture the rod (H).
10. Hang the rod (H) to the collar loop (D).
11. Measure the wires then cut, be certain to leave enough length to connect the wires in the
junction box.
12.. Strip the insulation on the fixture wires about 5/8".
13. Loosen the collar ring (E) and let the canopy (D) slip down the chain (F) carefully.
14. Twist the fixture wires together and push through the center hole of the collar loop (D).
Halle Medium Wide Lantern
Item# S 5196
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
ASSEMBLY INSTRUCTIONS
US
M
L
I
D
S
E
T
A
B
C
K
O
E
F
G
D
L
M
N
H
I
J
P
DAMP
L
M
N