Installation Sheet

ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Thread the top of fixture (J) onto nipple (M).
2. Install the crossbar(B) with ceiling loop(D) to outlet box by using mounting
screws(C) provided.
3. Put canopy(E) to ceiling loop, and secure with lock collar(F).
4. Using the dimensions of the fixture as a guide, shorten the chain(G) as needed
using a pair of chain pliers.
5. Take into consideration that you will use the chain end link to mount the
chandelier once you have removed the excess chain.
6. Unscrew the threaded collar on the chain end link. Attach the chain to the
ceiling loop(D). Close the threaded collar to secure the chain.
7. Unscrew the threaded collar on the other chain end link. Raise the fixture and
attach chain end link to the top ring(H). Close the threaded collar to secure the
fixture body.
8. Unwrap the wiring from the top of the fixture body. Weave the power supply
cord and the ground wire through the chain(F).
9. When you reach the canopy and ceiling loop, measure the wires and cut. Be
certain to leave enough to connect inside the canopy.
10. Strip the insulation back on the two power supply wires about 5/8”.
11. Twist the power supply and ground wires together and push through the center
hole in the ceiling loop.
12. Loosen the clock collar(F), let the canopy(E) slip down the chain carefully.
DRY
Country Large Chandelier
Item # S5212