Installation Sheet
ASSEMBLY INSTRUCTIONS
Presidio Small Pendant
Item # S 5673
.
DAMP
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED
ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Carefully remove all parts from the carton.
2. Place glass (H) onto the top of shade holder (I).p
3. Feed wire through all of the connetion rod (G), (F) and mounting loop (C).
4. Hook connection rod (G) on top loop of shade holder (I).
5. Hook connection rod (G) on top of connection rod (F).
6. Hook connection rod (F) to mounting loop (C).
7. Unscrew canopy ring (E), slide canopy ring (E) and canopy (D) on connection rod (F).
8. Attach mounting strap (A) to ceiling outlet box and secure with mounting screws (B).
9. Attach mounting loop (C) to thread nipple in center of mounting strap (A).
10. Attach the bare copper ground wire from the fixture to the ground junction box wire (usually green
or copper), fasten together with a plastic wire connector. Tightly wrap the wire connector
with electrical tape. Be sure no wire strands are exposed. IT IS IMPERATIVE THAT THE
OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.
11. Connect neutral wire from fixture (ridges molded wire) to the neutral wire from the junction box
(usually white) . Fasten both wires together with a plastic wire connector and tightly wrap the
wire connector with electrical tape. Be sure no wire strands are exposed.
12. Connect the hot wire from the fixture (smooth wire) to the hot wire (usually black ) from the
junction box. Fasten both together with a plastic wire conncetor and wrap the connection with
eletrical tape. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OTHERWISE
SAFETY WILL BE COMPROMISED.
13. Tuck the wire connections neatly into the ceiling outlet box.
14. Slip canopy (D) to ceiling and secure with canopy ring (E).
15. Remove socket ring (L) and washer (K) from socket, attach shade (J) to bottom of shade holder (I)
and secure with washer (K) and socket ring (L).
16. Insert light bulb into socket.
17. Restore power and test fixture. Installation is complete.
*** Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
F
G
H
I
D
E
A
B
C
J
L
K