Installation Sheet

Table Of Contents
ASSEMBLY INSTRUCTIONS
Hall Medium hanging Lantern
Item # S 5793
.
DAMP
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED
ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Carefully remove all parts from the carton.
2. Insert light bulbs (not included) into sockets.
3. Remove metal tabs (M) by removing screws (L), install glass panels (K) to each frame
of lantern box (J) and secure with metal tabs (M) and screws (L).
4. Feed the wires through the connection rod (H), connector (G) and connection rod (F).
5. Hook connection rod (H) to top loop (I).
6. Screw connector (G) onto the top nipple of connection rod (H) by turning in a clockwise
direction until tight.
7. Thread the bottom nipple of connection rod (F) into the connector (G) by turning in a
clockwise direction until tight.
8. Unscrew canopy collar (E), slide canopy collar (E) and canopy (D) on connection rod (F).
9. Attach mounting strap (A) to ceiling outlet and secure with mounting screws (C) provided.
10. Hook connection rod (F) to mounting loop (B).
11. Attach the bare copper ground wire from the fixture to the ground junction box wire (usually
green or copper), fasten together with a plastic wire connector. Tightly wrap the wire connector
with electrical tape. Be sure no wire strands are exposed. IT IS IMPERATIVE THAT THE
OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.
12. Connect neutral wire from fixture (ridged, molded wire) to the neutral wire from the junction box
(usually white) . Fasten both wires together with a plastic wire connector and tightly wrap the
wire connector with electrical tape. Be sure no wire strands are exposed.
13. Connect the hot wire from the fixture (smooth wire) to the hot wire (usually black ) from the
junction box. Fasten both together with a plastic wire connector and wrap the connection with
electrical tape. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OTHERWISE
SAFETY WILL BE COMPROMISED.
14. Tuck the wire connections neatly into the ceiling outlet box.
15. Slip canopy (D) to the affixed mounting strap (A) and secure with canopy collar (E).
16. Restore power and test fixture. Installation is complete.
*** Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
A
D
B
F
G
H
E
C
I
L
J
K
L
M
M

Summary of content (1 pages)