Installation Manual

1. Carefully remove all parts from the box. Place on a clean, soft surface.
2. Remove collar ring (E) from collar loop (C).
3. Install mounting plate (A) to junction box and secure with mounting
screws (B).
4. Secure collar loop (C) to mounting plate (A) using pliers to tighten
lock nut.
5. Install canopy (D) to collar loop (C) and secure with collar ring (E).
6. Remove metal bars (M) from fixture frame (J) by removing
screws (L).
7. Install light bulbs into the sockets.
8. Install glass panels (K) to fixture frame (J) and secure with metal
bars (M) using screws (L) (see diagram 1).
9. Feed fixture wire and ground wire through bottom rod (H) and top
rod (F).
10. Connect top rod (F) to coupling (G), then attach to fixture loop (I) and
collar loop (C). Secure links at ends of rods.
NOTE: Ensure there is no tension on the wires. Cut excess wires,
being sure to leave about 12” to reach the junction box.
11. Separate two sides of molded wire, and strip insulation on each 5/8".
12. Loosen collar ring (E) and let canopy (D) slip down rods carefully.
Halle Wide Hanging Lantern
Item # S 5797
ASSEMBLY INSTRUCTIONS
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction
and operation of it, as well as the hazards involved. Inspect item and
contents carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver
Slotted Screwdriver
Wire Cutters
Slip Joint Pliers Wire Strippers
NOTICE:
US
M
L
I
D
S
E
T
DAMP
C
A
B
D
E
F
G
I
Bulbs not included
H
J
K
L
M
J
Diagram 2
Diagram 1