Installation Sheet

ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Carefully hang the pipe (B) into the loop (A) and ring on sample ring.
2. Carefully hang the pipe (B) into the loop (C) on large ring and loop under
sample ring.
3. Thread the finial (E) into large ring (D) and sample ring.
4. Loosen the collar ring to release the canopy. Care fully ship the collar ring and
canopy down over the chain to rest on the fixture body. Don not scratch the
finish.
5. If you are certain that the height of the fixture is correct, cut the wires leaving
12” length from the top of the fixture.
6. Using the proper wire stripper, remove 5/8” of insulation from both fixture
wires
7. Carefully attach the nipple and cross bar to the top of the fixture. You do not
need to tighten at this time. Be certain to include both lock nuts between the
collar and the cross bar. They are very important to installing the fixture.
8. Carefully raise the fixture to the outlet box and attach the cross bar to the
outlet box using the appropriate screws. Be very careful not to pinch the wires
between the outlet box and cross bar.
9. Install the cross bar to the outlet box in your ceiling using the appropriate
screws. Be certain your outlet box is secure and that nothing is loose.
10. Rotate the fixture now to the position desired. Make certain that you do not
unscrew the fixture from the cross bar.
11. Once you are certain the fixture is in the proper position, tighten the lock nuts
against the collar and cross bar very tightly so that the fixture now cannot be
rotated.
DRY
Canopy
Crossbar
Collar ring
Collar loop
Top loop
Chain
( E )
(
D
)
( C )
(
B
)
( A )
Shade
Classic Two-Tier Ring Chandelier
Item # SL5813