Installation Sheet

SP1508
ASSEMBLY & INSTALLATION GUIDE
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR
OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Join lamp pole (C) and lamp base (D) together, letting bottom nipple of the lamp pole (C) pass through the hole on
lamp base (D).
2. From the underside of base, slide the washer (E) over the threaded nipple and then thread nut (F) onto the nipple.
Use the wrench (G) to tighten the nut.
3. Slide shade (A) onto socket housing (B).
4. Insert light bulb (not included) into socket.
5. Remove protective plastic (J) from electrical plug (H).
6. Plug lamp into wall outlet.
7. ADJUSTMENT:
To adjust the lamp by pull up or push down the upper pole, please note that pull the cord from the cord exit hole is
needed when pushing down the upper pole.