Installation Sheet

ASSEMBLY INSTRUCTIONS

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Remove mounting plate (A) from base of light ﬁxture (D) by removing base

screws (C) in counter-clockwise direction.

2. Afﬁx mounting plate (A) to wall outlet box with mounting screws (B) provided.

3. Attach ground (green or green/yellow) wire to ground wire from wall outlet

box (usually green or copper in color ), fasten together with a plastic wire

connector. Tighten wrap the wire connecto with electrical tape. so the end

of the connector is sealed. IT IS IMPERATIVE THAT THE OUTLET BOX IN

YOUR HOME BE PROPERLY GROUNDED.

4. Connect neutral (white ) ﬁxture wire coming from ﬁxture base to neutral

(usually white) outlet wire. Fasten both wires together with a plastic wire

connector and tightly wrap the wire conncetor with electrical tape.

5. Repeat the procedure with the hot (black) wires. Always make sure that

no wire strands are left outside the connectors. DO NOT REVERSE THE

HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL BE

COMPROMISED.

6. Attach ﬁxture base (D) to the afﬁxed mounting plate (A) and tighten with base

screws (C).

7. Remove socket ring (G) from threaded socket (E), place lamp shade (F) onto

the threaded section of socket (E) and secure with socket ring (G).

8. Insert light bulb (not included) into socket.

*** Clean with a dry, soft cloth only. Do not use harsh abrasives or chemical agents.

DRY

Dalston Sconce

Item # SP2017