Installation Sheet

ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Install the crossbar(B) with ceiling loop(D) to outlet box by using mounting
screws(C) provided.
2. Loosen the lock collar(F) and raise the canopy(E) to ceiling loop(D), then
thread lock collar(F) loosely to secure.
3. Using the dimensions of the fixture as a guide, shorten the chain(G) as needed
using a pair of chain pliers.
4. Take into consideration that you will use the chain end link to mount the
pendant once you have removed the excess chain.
5. Unscrew the threaded collar on the chain end link. Attach the chain end link to
the ceiling loop(D).
6. Attach the chain(G), now desired length, to the chain end link. Close the
threaded collar to secure the chain(G).
7. Unscrew the threaded collar on the other chain end link. Attach the chain end
link to the lower end of the chain.
8. Carefully lift and hang the fixture assembly(H) by the chain end link.Close the
threaded collar on the chain end link to secure.
9. Unwrap the wiring from the top of the fixture assembly. Weave the power
supply cord and the ground wire through the chain.
10. When you reach the canopy and ceiling loop, measure the wires and cut. Be
certain to leave enough to connect inside the canopy. Strip the insulation back
on the two power supply wires about 5/8”.
11. Twist the power supply and ground wires together and push through the center
hole in the ceiling loop.
12. Loosen the lock collar and slip the canopy down the chain.
DRY
Star Lantern
Item # SP5004

Summary of content (2 pages)