Installation Sheet

ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Attach chain (G) to top loop (H) by opening/closing end link of chain.
2. Unscrewing canopy ring (F), slide canopy ring (F) and canopy (E) on chain (G).
3. Feed wire through chain (G), canopy (E) and mounting loop (D).
4. Attach mounting strap (A) to ceiling outlet box and secure with mounting
screws (B).
5. Insert top thread nipple (C) in mounting strap (A).
6. Attach mounting loop (D) to thread nipple (C).
7. Attach chain with light fixture to mounting loop (D) at desired height.
8. Attach the bare copper ground from the fixture to the ground junction box
wire (usually green or copper), fasten together with a plastic wire connector.
Tighten wrap the wire connector with electrical tape. Be sure no wire strands
are exposed. IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME
BE PROPERLY GROUNDED.
9. Connect neutral wire from fixture (ridges molded wire) to the neutral wire from
the junction box (usually white) . Fasten both wires together with a plastic wire
connector and tightly wrap the wire conncetor with electrical tape. Be sure no
wire strands are exposed.
10. Connect the hot wires from the fixture (smooth wire) to the hot wire (usually
black ) from the junction box. Fasten each together with a plastic wire
conncetor and wrap the connection with eletrical tape. DO NOT REVERSE
THE HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL BE
COMPROMISED.
DRY
Dalston Medium Hanging Pendant
Item # SP5020
A
B
E
F
C
D
G
H
I
J
K

Summary of content (2 pages)