Installation Sheet

TOB1010
ASSEMBLY & INSTALLATION GUIDE
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR
OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Loosen set screw (H) using allen key (J), adjust tripod base to desired height, tighten the set screw with allen key (J).
2. Thread rod (D) into top threaded opening of part (E).
3. Remove finial (A) from rod (B), place lamp shade (not included) over top threaded section of rod (B), and secure with
finial (A).
4. Remove protective plastic (L) from electrical plug (K).
5. Insert light bulbs into sockets
6. Plug lamp into wall outlet.
7. ADJUSTMENT INSTRUCTIONS:
1) Loosen adjustment key (C), (F) or (G) found on lamp stem.
2) Adjust height by pulling or pushing lamp pole up or down to desired height.
3) Tighten the adjustment keys.
desired height, tighten the set screw with allen key (J).
2) Loosen set screw (H) using allen key (J), adjust tripod base to
(J)
(H)
(G)
(F)
(E)
2) Adjust height by pulling or pushing lamp pole up or down
ADJUSTMENT INSTRUCTIONS
1) Loosen adjustment key (C), (F) or (G) found on lamp stem.
to desired height.
3) Tighten the adjustment keys.
over top threaded section of rod (B), and secure with finial (A).
4) Remove finial (A) from rod (B), place lamp shade (not included)
(D)
(C)
(B)
7) Plug lamp into wall outlet.
1) Remove all parts carefully from box.
3) Thread rod (D) into top threaded opening of part (E).
6) Insert light bulbs Type A, maximum 100 Watt into scokets.
5) Remove protective plastic (L) from electrical plug (K).
(K)
(L)
ITEM REFERENCE NUMBER: TOB 1010
(A)