Installation Sheet

ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. To detach mounting plate (B) from fixture base (F) by removing base screws (E).
2. Place mounting plate (B) on the wall outlet box, use it as a template, and
mark two points for both mounting holes of mounting plate (B). Remove
mounting plate (B).
NOTE: Item can be installed both horizontally and vertically.
3. Drill small holes on the marked points, the holes should be big enough to
accommodate with plastic anchors (A). Push plastic anchors (A) into the
holes.
4. Gently pull the wires from the wall outlet and allow the wires to hang. Thread
the wires through the center hole in mounting plate (B).
5. Attach mounting plate (B) to wall outlet box by aligning the holes, inserting
mounting screws (C) to the of wall outlet holes box and inserting screws (D)
to secure mounting screws (C) to the wall.
6. Attach ground (green) wire to ground wire from wall outlet box (usually
green or copper in color), fasten together with a plastic wire connector.
Tightly wrap the wire connector with electrical tape so the end of the
connector is sealed.
IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE
PROPERLY GROUNDED.
7. Connect neutral (white) fixture wire coming from fixture base to neutral
(usually white) outlet wire. Fasten both wires together with a plastic wire
connector and tightly wrap the wire connector with electrical tape.
DRY
Keeley Tall Pivoting Sconce
Item # TOB2031