Installation Sheet

1. Carefully remove all parts from the box.

2. Remove the shade (I) from the fixture body (E) by unscrewing the thumbscrews (G).

3. Remove the mounting plate (B) from the fixture body (E) by unscrewing the side screws (F).

4. Put the mounting plate (B) on the wall, mark the anchor holes position with pencil

(not included). Drill holes on the wall and insert the anchors (A) into the holes.

5. Install the mounting plate (B) to the junction box and secure with the mounting screws (C),

then secure the wood screws (D) to the anchors (B) and lock tight.

6. Wrap the fixture ground wire to the green ground screw on the mounting plate (B) and

secure, then connect to the ground wire in the junction box using the wire nut (H).

IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.

7. Connect the fixture white wire to the neutral wire in the junction box using the wire nut (H).

8. Connect the fixture black wire to the hot wire in the junction box using the wire nut (H).

DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL

BE COMPROMISED.

9. Install the fixture body (E) to the mounting plate (B) and secure with the side screws (F).

10. Insert bulbs (not included) into the sockets.

11. Install the shade (I) to the fixture body (E) and secure with thumbscrews (G).

12. Installation is complete, turn on power at fuse or circuit breaker.

***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.

Dresser Long Glass Rod Light

Item # TOB2141

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED ELECTRICIAN.

WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY

DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO

REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND

INSTALLATION ARE FINAL.

ASSEMBLY INSTRUCTIONS

DAMP

PAGE 1
Dresser Long Glass Rod Light Item # TOB2141 ASSEMBLY INSTRUCTIONS WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN. WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL. G ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED. NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO REMOVING.