Manualshelf

Installation Sheet

ManualsBrandsVisual Comfort ManualsBathroom LightsBryant 20" Bath Light by Thomas O'Brien
1
TOB2153
ASSEMBLY & INSTALLATION GUIDE
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT
BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR
OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Attach ground (green) wire to ground wire from wall outlet box (usually green or copper in color), fasten together with
a plastic wire connector. Tightly wrap the wire connector with electrical tape so the end of the connector is sealed. IT
IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.
2. Connect neutral (white) fixture wire coming from fixture base to neutral (usually white) outlet wire. Fasten both wires
together with a plastic wire connector and tightly wrap the wire connector with electrical tape.
3. Repeat the procedure with the hot (black) wires. Always make sure that no wire strands are left outside the
4. connectors. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE
COMPROMISED.
5. Remove mounting plate (A) from fixture base (D) by removing base screws (C).
6. Affix mounting plate (A) to wall outlet box with mounting screws (B) provided.
7. Attach fixture base (D) to affixed mounting plate (A) and tighten with base screws (C).
8. Attach glass shade (F) over the threaded section of socket (E), and secure with spring washer (G) & socket ring (H).
Tighten by wrench (J) provided.
9. Insert light bulb into sockets.
10. INSTRUCTIONS FOR MOUNTING FIXTURE OUTDOORS AND/OR IN WET LOCATION:
a. Mounting surface should be clean, dry, flat and 1/4” larger than canopy/fixture base on all sides. Any gaps
between the mounting surface and canopy/fixture base exceeding 3/16” should be corrected as required.
b. With silicone (ex. GE-108) caulking compound, caulk completely around where back of canopy/fixture base meets
the wall surface to prevent water from seeping into outlet box.

Summary of content (1 pages)