Installation Sheet

TOB2198

ASSEMBLY & INSTALLATION GUIDE

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT

BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR

OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Remove mounting plate (B) from ﬁxture base (F) by removing base screws (E).

2. Place mounting plate (B) on the wall outlet box, use is as a template, mark center points for four mounting holes on

the mounting plate (B). Remove mounting plate (B).

3. Drill small holes on the marked location, the holes should be big enough to accommodate with plastic anchors (A).

Push plastic anchors (A) into the holes.

4. Attach ground (green) wire to ground wire from wall outlet box (usually green or copper in color), fasten

5. together with a plastic wire connector. Tightly wrap the wire connector with electrical tape so the end of the

connector is sealed. IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.

6. Connect neutral (white) ﬁxture wire coming from ﬁxture base to neutral (usually white) outlet wire. Fasten both wires

together with a plastic wire connector and tightly wrap the wire connector with electrical tape.

7. Repeat the procedure with the hot (black) wires. Always make sure that no wire strands are left outside

the connectors. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE

COMPROMISED.

8. Afﬁx mounting plate (B) to wall outlet box, inserting mounting screws (D) and screws (C) to secure

9. mounting plate (B) to wall.

10. Attach ﬁxture base (F) to afﬁxed mounting plate (B) and tighten by inserting base screws (E). Insert light bulb into

socket (G).

11. Remove end cap (H) & part (K), insert one end of glass shade (G) into lower end of ﬁxture base (F), replace part (K)

& end cap (H) to secure the glass shade to the ﬁxture.