Installation Sheet

TOB2204
ASSEMBLY & INSTALLATION GUIDE
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR
OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Measure center distance of both hanging key holes at backside of lamp base (C). Mark hole locations on the wall
with the same distance at desired height.
2. Drill small hole on each marked location on the wall, each hole should be large enough to accommodate
3. the plastic anchor (A). Push plastic into the holes in the wall.
4. Insert both mounting screws (B) into the plastic anchors (A), make sure both screw heads with threads are visible.
5. Hook lamp base (C) to the affixed screws (B) by aligning the holes on backside oflamp base (C) with both screw
heads.
6. Remove plastic bushing inside of threaded hole at bottom of fixture base (C).
7. Attach cord cover (G) to bottom of fixture base (C) by turning (G) in counter-clockwise direction.
8. Attach cord cover (H) to bottom of (G) by turning (H) in counter-clockwise direction and attach cord cover (J) to
bottom of (H) by turning (J) in counter- clockwise direction
9. Remove finial (F) from harp (D). Place shade (E) over the bolt attached on the top of harp (D). Screw finial (F) onto
the bolt to secure shade to the harp.
10. Install bulb of correct type and wattage. See label on lamp.
11. Remove plastic cover (L) from electrical plug (K).
12. Plug lamp into wall outlet.
**For your convenience, DW plug is provided and attached in the plastic at the end of the cord.**