Installation Sheet

ASSEMBLY INSTRUCTIONS

WE RECOMMMEND INSTLLATION OF THIS LIGHTING FIXTURE BE DNE BY A

LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Attach ground (green) wire to ground wire from wall outlet box (usually green

or copper in color), fasten together with a plastic wire connector. Tightly wrap

the wire connector with electrical tape so the end of the connector is sealed.

IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE

PROPERLY GROUNDED.

2. Connect neutral (white) ﬁxture wire coming from ﬁxture base to neutral (usually

white) outlet wire. Fasten both wires together with a plastic wire connector and

tightly wrap the wire connector with electrical tape.

3. Repeat the procedure with the hot (black) wires. Always make sure that no

wire strands are left outside the connectors.

DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY

WILL BE COMPROMISED.

4. Remove mounting plate (A) from ﬁxture base (D) by removing base screws (C).

5. Afﬁx mounting plate (A) to wall outlet box with mounting screws (B) provided.

6. Attach ﬁxture base (D) to afﬁxed mounting plate (A) and tighten with base

screws (C).

7. Remove the cap (G) from top opening of shade holding frame (E).

8. Insert light bulb into socket.

9. Insert the glass cylinder (F) into shade holding frame (E) and screwing cap (G)

to top opening of shade holding frame (E) to secure glass cylinder (F) to the

shade holding frame.

10. Please see page 2 for instructions to mount in damp/wet locations.

Merchant Single Bath Light

Item # TOB2206

WET

PAGE 1
ASSEMBLY INSTRUCTIONS Merchant Single Bath Light Item # TOB2206 WE RECOMMMEND INSTLLATION OF THIS LIGHTING FIXTURE BE DNE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED. 1.
PAGE 2
ASSEMBLY INSTRUCTIONS Merchant Single Bath Light Item # TOB2206 WE RECOMMMEND INSTLLATION OF THIS LIGHTING FIXTURE BE DNE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED. INSTRUCTIONS FOR MOUNTING FIXTURE OUTDOORS AND/OR IN WET LOCATION: 1.