Installation Sheet
ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Remove mounting plate (A) from fixture base (D) by removing base screws (C).
2. Gently pull the wires from the wall outlet and allow the wires to hang. Thread
the wires through the center hole in mounting plate (A).
3. Affix mounting plate (A) to wall outlet box with mounting screws (B) provided.
4. Attach ground (green) wire to ground wire from wall outlet box (usually green
or copper in color), fasten together with a plastic wire connector. Tightly wrap
the wire connector with electrical tape so the end of the connector is sealed.
IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE
PROPERLY GROUNDED.
5. Connect neutral (white) fixture wire coming from fixture base to neutral (usually
white) outlet wire. Fasten both wires together with a plastic wire connector and
tightly wrap the wire connector with electrical tape.
6. Repeat the procedure with the hot (black) wires. Always make sure that no
wire strands are left outside the connectors.
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY
WILL BE COMPROMISED.
7. Attach fixture base (D) to affixed mounting plate (A) and tighten with base
screws (C). Make sure the direction of fixture base (D) is follow the direction
label showen at backside of fixture base (D). This way will avoid the water
enter/keep inside of shade.
8. Remove caps (G) from top opening of shade holding frames (E). Insert light
bulbs into sockets.
9. Insert the glass cylinders (F) into shade holding frames (E) and screwing caps
(G) to the both side opening of shade holding frames (E) to secure glass
cylinders (F) to the shade holding frames.
WET
Merchant Double Bath Light
Item # TOB2207