Installation Sheet

ASSEMBLY INSTRUCTIONS

Osiris Single Reflector Sconce

Item # TOB 2290

DRY

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED

ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Carefully remove all parts from the carton.

2. Remove mounting plate (A) from base of light fixture (D) by removing base screws (C)

in counter-clockwise direction.

3. Affix mounting plate (A) to wall outlet box with mounting screws (B) provided.

4. Attach ground (green or green/yellow) wire to ground wire from wall outlet box (usually green or

copper in color ), fasten together with a plastic wire connector. Tightly wrap the wire connector

with electrical tape. so the end of the connector is sealed. IT IS IMPERATIVE THAT THE

OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.

5. Connect neutral (white ) fixture wire coming from fixture base to neutral (usually white )

outlet wire. Fasten both wires together with a plastic wire connector and tightly wrap the

wire connector with electrical tape.

6. Repeat the same procedure with the hot (black) wires. Always make sure that no wire strands are

left outside the connectors. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS

OTHERWISE SAFETY WILL BE COMPROMISED.

7. Attach fixture base (D) to the affixed mounting plate (A) and tighten with base screws (C).

8. Remove socket ring (G) from socket (E), place the bracket of reflector (F) onto threaded section of

socket (E) and secure with socket ring (G).

9. Insert the specified light bulb into socket.

10. Restore power and test fixture. Installation is complete.

*** Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.