Installation Sheet
ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Remove back plate (B) from fixture base (E) by removing base screws (D).
2. Place back plate (B) vertically onto wall outlet box, use it as a template, mark
center point locations for both mounting slots of back plate (B) on the wall.
Remove back plate (B).
3. Drill small holes on marked points on the wall, each hole should be large
enough to accommodate the plastic anchors (A). Push plastic anchors (A) into
the holes in the wall.
4. Gently pull the wires from the wall outet and allow the wires to hang.
Thread the wires through the center hole in back plate (B).
5. Attach back plate (B) to the wall by aligning the mounting holes of back plate
(B) with plastic anchors (A), inserting screws (C) to secure back plate to
the wall.
6. Attach ground (green) wire to ground wire from wall outlet box (usually green
or copper in color), fasten together with a plastic wire connector. Tightly wrap
the wire connector with electrical tape so the end of the connector is sealed.
IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE
PROPERLY GROUNDED.
7. Connect neutral (white) fixture wire coming from fixture base to neutral (usually
white) outlet wire. Fasten both wires together with a plastic wire connector and
tightly wrap the wire connector with electrical tape.
8. Repeat the procedure with the hot (black) wires. Always make sure that no
wire strands are left outside the connectors.
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS
OTHERWISE SAFETY WILL BE COMPROMISED.
DRY
Modern Library Sconce
Item # TOB2327