Installation Sheet

TOB2604

ASSEMBLY & INSTALLATION GUIDE

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT

BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR

OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Remove back plate (B) from ﬁxture base (E) by unscrewing base screws (F) in counter-clockwise direction.

2. Position back plate (B) horizontally on the wall outlet box. Mark center points for both key holes with a pencil. Remove

back plate (B).

3. Drill small holes on each point locations on the wall, each hole should be large enough to accommodate the plastic

anchors (A). Push plastic anchors (A) into the holes in the wall.

4. Gently pull the wires from the wall outlet and allow the wires to hang. Thread the wires through the center hole in

back plate (B).

5. Attach ground (green) wire to ground wire from wall outlet box (usually green or copper in color), fasten together with

a plastic wire connector. Tightly wrap the wire connector with electrical tape so the end of the connector is sealed. IT

IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.

6. Connect neutral (white) ﬁxture wire coming from ﬁxture base to neutral (usually white) outlet wire. Fasten both wires

together with a plastic wire connector and tightly wrap the wire connector with electrical tape.

7. Repeat the procedure with the hot (black) wires. Always make sure that no wire strands are left outside the

connectors. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL BE

COMPROMISED.

8. Afﬁx back plate (B) to wall by aligning holes and secure by inserting mounting screws (C) to the holes of outlet box

and screws (D) to the plastic anchors (A) in the wall.

9. Attach ﬁxture base (E) to back plate (B) and secure by inserting base screws (F).

10. Insert light bulb into socket.

PAGE 1
TOB2604 ASSEMBLY & INSTALLATION GUIDE WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED. 1. Remove back plate (B) from fixture base (E) by unscrewing base screws (F) in counter-clockwise direction.