Installation Sheet

ASSEMBLY INSTRUCTIONS

Library 22” Picture Light

Item # TOB2606

DRY

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED

ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Carefully remove all parts from the carton.

2. Remove back plate (B) from base of light fixture (E) by removing base screws (F) in

counter-clockwise direction.

3. Position back plate (B) horizontally on the wall outlet box. Mark center points for both

key holes with a pencil. Remove back plate (B).

4. Drill small holes on each point location on the wall, each hole should be large enough to

accomodate the plastic anchor (A). Push plastic anchors (A) into the holes in the wall.

5. Gently pull the wires form the wall outle and allow the wires to hang. Thread the wires

through the center hole in back plate (B).

6. Attach ground (green) wire to ground wire from wall outlet box (usually green or copper

in color ), fasten together with a plastic wire connector. Tighten wrap the wire

with electrical tape. so the end of the connector is sealed. IT IS IMPERATIVE THAT THE

OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.

7. Connect neutral (white ) fixture wire coming from fixture base to neutral (usually white )

outlet wire. Fasten both wires together with a plastic wire connector and tightly wrap the

wire conncetor with electrical tape.

8. Repeat the procedure with the hot (black) wires. Always make sure that no wire strands are

left outside the connectors. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS

OTHERWISE SAFETY WILL BE COMPROMISED.

9. Affix back plate (B) to wall by aligning holes and secure by inserting mounting screws (D) to

the holes of outlet box and screws (C) to the plastic anchors in the wall.

10. Attach fixture base (E) to back plate (B) and secure by inserting base screws (F).

11. Insert light bulbs into sockets.

*** Clean with a dry, soft cloth only. Do not use harsh abrasives or chemical agents.