Installation Sheet
ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Remove mounting plate (A) from base of light fixture (D) by removing base
screws (C) in counter-clockwise direction.
2. Affix mounting plate (A) to wall outlet box with mounting screws (B) provided.
3. Attach ground (green) wire to ground wire from wall outlet box (usually green
or copper in color ), fasten together with a plastic wire connector. Tighten
wrap the wire connecton with electrical tape. so the end of the connector is
sealed. IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE
PROPERLY GROUNDED.
4. Connect neutral (white ) fixture wire coming from fixture base to neutral
(usually white) outlet wire. Fasten both wires together with a plastic wire
connector and tightly wrap the wire conncetor with electrical tape.
5. Repeat the procedure with the hot (black) wires. Always make sure that
no wire strands are left outside the connectors. DO NOT REVERSE THE
HOT AND NEUTRAL CONNECTIONS OTHERWISE SAFETY WILL BE
COMPROMISED.
6. Attach fixture base (D) to the affixed mounting plate (A) and tighten with base
screws (C).
7. Remove socket ring (G) from threaded socket (E), place the bottom ring of
harp (F) onto the threaded section of socket (E) and secure with socket ring (G).
8. Remove finial (J) from harp (F), place shade (H) over the bolt attached on top
of harp (F). Screw finial (J) onto the bolt to secure shade (H) to harp (F).
9. Insert light bulb (not included) Type A, maximum 60 watt into socket.
*** Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
DRY
Edie Sconce
Item # TOB2740
E
A
B
C
D
G
F
H
J