Installation Sheet

TOB5011

ASSEMBLY & INSTALLATION GUIDE

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT

BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR

OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Attach ground ﬁxture wire (silver or copper in color) to ground wire from wall outlet box (usually green or copper

in color), fasten together with a plastic wire connector. Tightly wrap the wire connector with electrical tape so the

end of the connector is sealed. IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY

GROUNDED.

2. Connect neutral (white) ﬁxture wire coming from ﬁxture base to neutral (usually white) outlet wire. Fasten both wires

together with a plastic wire connector and tightly wrap the . wire connector with electrical tape.

3. Repeat the procedure with the hot (black) wires. Always make sure that no wire strands are left outside

the connectors. DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE

COMPROMISED.

4. To detach back plate (A) from light ﬁxture by unscrewing base screws (B).

5. Position back plate (A) diagonally so that the holes of back plate (A) and ceiling outlet box are aligned. Tighten the

mounting plate onto the ceiling outlet with mounting screws (C).

6. Gently push the ﬁxture base onto the afﬁxed back plate (A), and secure with base screws (B).

7. Thread shade support pole (E) to threaded opening at bottom of wire component (D).

8. Insert light bulbs into sockets.

9. Remove ﬁnial (F) from (E), clip shade spider onto threaded rod (G), attach shade diffuser over bottom threaded nipple

of (E), and secure with ﬁnial (F).