Installation Sheet

ASSEMBLY INSTRUCTIONS
WE RECOMMMEND INSTLLATION OF THIS LIGHTING FIXTURE BE DNE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Screw fixture stem onto threaded rod on top of fixture body.
2. Attach ceiling box strap to ceiling outlet box using proper size screws and
tighten securely.
3. Attach nipple into ceiling box strap and lock into place using included nut. Attach
screw collar loop to nipple and lock into place using included nut. Be certain
to use the canopy and screw collar to check that it will fit flush before locking
everything into place.
4. Install canopy against ceiling and loosely install screw collar.
5. Loosen the screw collar from the loop and slip it and the canopy down over the
connection rods.
6. Attach the steel support cable (if applicable) to the structure of the house.
Separate the power wires coming from the fixture by gently pulling them apart
from one another. You will need to separate at least 8”.
7. Strip 5/8” insulation from each of the two power wires coming from the fixture
using properly gauged wire strippers.
8. Attach ground (copper or silver in color) fixture wire to ground wire from ceiling
outlet box (usually green or copper in color), and fasten together with a plastic
wire connector. Tightly wrap the wire connector with electrical tape so the end of
the connector is sealed.
IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY
GROUNDED.
9. Connect the neutral (RIBBED, without any marking) fixture wire to the neutral
(usually white) wire from ceiling outlet box. Fasten both wires together with a
plastic wire connector and tightly wrap the wire connector with electrical tape.
Goodman Large Hanging Lamp
Item # TOB5014
DRY