Installation Sheet
ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Install the ceiling loop into the top of the junction box. Leave the loop loose
while you place the canopy and lock collar into place to set the depth of the
loop. Once you have made certain that the canopy and lock collar will install
easily, secure the ceiling loop, by tightening the hickey into place. Tighten all
hex nuts using an adjustable wrench and a pair of pliers.
2. Install the canopy and loosely install the lock collar.
3. Using the dimensions of the fixture as a guide, shorten the chain provided
using a pair of chain pliers.
4. Take into consideration that you will use the chain end link to mount the
chandelier once you have cut the chain.
5. Unscrew the collar on the chain end link. Attach the chain end link to the
ceiling loop.
6. Attach the chain (now desired length) to the chain end link. Close the threaded
collar to secure the chain.
7. Unscrew the threaded collar on the other chain end link. Attach the chain end
link to the lower end of the chain.
8. Carefully lift the Column Assembly from the box.
9. Hang the Column Assembly by the chain end link.
10. Close the threaded collar on the chain end link to secure.
11. Unwrap the wiring from the top of the Column Assembly.
12. Gently remove glass arm from the package.
13. Remove the lock nut and spring washer from the nipple at the end of the arm.
14. Slip the wires through the hole in the center plate.
DRY
Quick link
Canopy
Ceiling loop
Screw
crossbar
Fixture
Ground Wire
Fixture Wires
Junction box
Nipple
Hex Nut
Lock collar
Vivian Mini Chandelier
Item # TOB5031