Installation Sheet

ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Install the crossbar(B) with ceiling loop(D) to outlet box by using mounting
screws(C) provided.
2. Thread the lock collar(F) to ceiling loop(D) to secure canopy(E).
3. Using the dimensions of the fixture as a guide, shorten the chain(G) as needed
using a pair of chain pliers.
4. Take into consideration that you will use the chain end link to mount the
chandelier once you have removed the excess chain.
5. Attach the chain end link to the ceiling loop(D).
6. Carefully lift and hang the fixture assembly to the chain end link.
7. Unwrap the wiring from the top of the fixture assembly, Weave the power
supply cord and the ground wire through the chain(G).
8. When you reach the canopy(E) and ceiling loop(D), measure the wires and cut.
Be certain to leave enough to connect inside the canopy,
9. Unscrew the threaded collar and slide canopy down on the chain.
10. Twist the power supply and ground wires together and push through the center
hole in the ceiling loop, Strip the insulation back on the two power supply wires
about 5/8”.
11. Identify the hot wire from the fixture by feeling the edges. The hot wire is
smooth and has words printed on it. The common wire is ribbed and has no
words on it.
12. Attach the bare wire from the fixture to the bare wire from the building using
the provided wire nuts(A). If you house has no bare wire (ground) attach this
wire to the green grounding screw inside the outlet box.
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
DRY
Elizabeth Chandelier
Item # TOB5036