Installation Sheet

1. Carefully remove all parts from the box. Place on a clean, soft surface.

2. Remove canopy (E) from collar loop (D) by unscrewing collar ring (F).

3. Install mounting plate (B) to junction box with mounting screws (C).

4. Secure collar loop (D) to mounting plate (B) using wrench to tighten

locknut.

5. Install canopy (E) to collar loop (D) and secure with collar ring (F).

6. Determine desired overall length, and amount of chain (G) needed.

Shorten chain using chain pliers. (Keep extra chain)

7. Attach chain (G) to collar loop (D) and to fixture body (H).

8. Thread fixture wire and ground wire through chain (G).

NOTE: When you reach the collar loop (D), ensure there is no tension

on the wires. Cut excess wires, being sure to leave about 12” to reach

the junction box.

9. Separate two sides of molded wire, and strip insulation on each 5/8".

10. Loosen collar ring (F) and let canopy (E) slip down chain (G) carefully.

11. Twist all fixture wires together. Slip through center hole of collar

loop (D).

NOTE: Untwist wires and separate to prepare for connection.

Piatto Medium Pendant

Item # TOB 5115

ASSEMBLY INSTRUCTIONS

DAMP

This light fixture should be installed in accordance with all applicable,

local installation codes, and by a person familiar with the construction

and operation of it, as well as the hazards involved. Inspect item and

contents carefully. If any damage or defect is found, do not install.

Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED):

Junction box

Bulb not included

Diagram 1

Phillips Screwdriver

Slotted Screwdriver

Chain Pliers

Slip Joint Pliers Adjustable Wrench Measuring Tape

Wire Cutters Wire Strippers

NOTICE:

PAGE 1
Piatto Medium Pendant ASSEMBLY INSTRUCTIONS Item # TOB 5115 NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
PAGE 2
Piatto Medium Pendant ASSEMBLY INSTRUCTIONS Item # TOB 5115 NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved. Junction box A 12.