Installation Sheet

ASSEMBLY INSTRUCTIONS
WE RECOMMMEND INSTLLATION OF THIS LIGHTING FIXTURE BE DNE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Install the mounting plate (B) with to outlet box by using mounting screws (C)
provided. Using the dimensions of the fixture as a guide, shorten the chain (J)
as needed using a pair of chain pliers.
2. Take into consideration that you will use the chain end link to mount the
chandelier once you have removed the excess chain. Unscrew the threaded
collar on the chain end link. Attach the chain to the ceiling loop. (E). Close the
threaded collar to secure the chain.
3. Unscrew the threaded collar on the other chain end link (G). Raise the fixture
and attach chain end link to the top ring (H). Close the threaded collar to
secure the fixture body.
4. Unwrap the wiring from the top of the fixture body. Weave the power supply
cord and the ground wire through the chain (J). When you reach the canopy
and ceiling loop, measure the wires and cut. Be certain to leave enough to
connect inside of the canopy. Strip the insulation back on the two power supply
wires about 5/8”.
5. Twist the power supply and ground wires together and push through the center
hole in the ceiling loop (E).
6. Connect the Ground (bare) wire with the ground (usually bare) wire from
your ceiling box using wire nut (A). If your house does not have ground wire,
then attach this wire to the green grounding screw inside of outlet box.
IT IS IMPERATIVE THAT THE J-BOX IN YOUR HOME BE PROPERLY
GROUNDED.
7. Connect the Neutral wire with the Neutral (usually white) wire from your ceiling
box using wire nut (A).
Katie Pendant
Item # TOB5226
DAM P
)