220/240, 100 VAC Touch and Go Blending Station Owner's Manual

ManualsBrandsVita-Mix ManualsBlender220/240

220/240 and 100 VAC Models

by any means, electronic or mechanical, including photocopy, recording or any information storage and retrieval system

without the written permission of the Vita-Mix Corporation.

VITA-MIX

CORPORATION

International Foodservice Division

8615 Usher Road, Cleveland, Ohio 44138-2103 USA

Printed in U.S.A

XBS011 05/01

Touch and Go

Blending Station

High Performance Commercial Blender

Owner’s Manual

Read And Save These Instructions

INTERNATIONAL

FOODSERVICE

Blending Station

On-Counter:

Height of unit closed: 54.56 cm • Shipping weight: 9.534 kg

Dimensions 54.56 cm H x 23.45 cm W x 25.86 cm D

Blending Station In-Counter:

Height of unit above counter: 44.45 cm closed

Depth of unit below counter: 14.4 cm • Shipping Weight: 8.172 kg

Dimensions: 45.03 cm H x 23.45 cm W x 25.86 cm D

NOTE: For In-Counter Installation refer to pages 8-10.

Power Requirements:

Volts: 220/240 VAC, 50 or 60 Hz, 1073-1178 Watts

100 VAC, 60 Hz, 900 Watts (Japan)

Warranty Information:

Call or check with your local distributor for details of any available warranty.

Provisions of any warranty are void if your Touch and Go

Blending

Station

has been subjected to obvious abuse, negligence, accident,

alteration, or failure to follow operating instructions, or product exposure

to abnormal or extreme conditions. Cosmetic changes such as discoloration

of parts of the product in the hands of the user or the effects of the use of

abrasive cleaners will not be warranted or considered defects. The cleaning

or removal of food products along with any damage caused by allowing

them to build-up is not covered by any warranty. Improper installation of

the in-counter model is not covered by this warranty. Also a warranty is void

if the Blending Station is put into a sound reduction chamber or otherwise

prevented from receiving proper cooling. In the event your Vita-Mix

appliance

needs service or repair, please call Vita-Mix Service at

1(440) 235-5494 for a

local distributor. In Latin America call

1(440) 235-0214 for a local distibutor.

pecifications

Summary of content (13 pages)

PAGE 1
S pecifications INTERNATIONAL F O O D S E R V I C E Blending Station® On-Counter: Height of unit closed: 54.56 cm • Shipping weight: 9.534 kg Dimensions 54.56 cm H x 23.45 cm W x 25.86 cm D Owner’s Manual Read And Save These Instructions Blending Station In-Counter: Height of unit above counter: 44.45 cm closed Depth of unit below counter: 14.4 cm • Shipping Weight: 8.172 kg Dimensions: 45.03 cm H x 23.45 cm W x 25.86 cm D NOTE: For In-Counter Installation refer to pages 8-10.
PAGE 2
IMPORTANT SAFEGUARDS 1. Read all instructions. 2. To protect against risk of electrical shock, do not put motor base in water or other liquid. 3. Close adult supervision is necessary when appliance is used by or near children. 4. Unplug the power cord from the wall outlet when the Touch and GoTM Blending Station ® is not in use, before putting on or taking off parts, and before cleaning other than washing the container. 5. Never contact moving parts. 6.
PAGE 3
C ontrol Panel Display Window Speed Control Start/Stop Due to the difference of recipes, your results may vary. See page 6 for information on Custom Programming these six buttons. DISPLAY WINDOW - This area depending on what button is pressed, displays a variety of operation messages. A ‘Ready’ message appears when there is power to the machine. OWNER CONTROLS - A control panel accessible by pressing the Vita-Mix logo. • Press once to reveal the mode message.
PAGE 4
. Within 10 seconds the SIX PRE-SET buttons will be re-programmed and the DISPLAY WINDOW will read ‘Saved’ then ‘Ready’. If nothing happens when the programming chip is fully inserted, turn the chip in the opposite direction and try again. 3. Remove the programming chip and return it to the original package. 5. Press one of the six PRE-SET buttons to reveal, in the DISPLAY WINDOW, the name of the program/drink. 6. Carefully place the Blending Station motor back into the hole in the counter.
PAGE 5
I n-Counter Installation Electrical requirements: • Volts: 220/240 VAC • 50 or 60 Hz. • 1073-1178 Watts • Volts: 100 VAC, 60 Hz., 900 Watts (Japan) Blending Station dimensions: Preparing the counter area: • Before cutting holes, make sure that there is adequate clearance under the counter for the motor. The motor will extend about 14.4 cm below the counter but it is best to allow at least 25.4 cm from the under-counter to shelves or any other equipment under the counter.
PAGE 6
I n-Counter Gasket Gasket Installation Instructions: 1. Follow the instructions on page 8 on preparing the counter area for the installation of your In-Counter Touch and GoTM Blending Station®. Also, use the Template Sheet (provided in your machine’s original package) to assist you in the placement and ventilation of your machine. 2. Peel off the white paper on the back of the black In-Counter Gasket Foam Pad to reveal the adhesive backing. 3.
PAGE 7
L id Assembly Tamper Two-part Lid One Piece Lid 1.5 Liter Polycarbonate container The two part lid is easy to clean and easy to put on, take off and seal. • To remove fully latched lid, squeeze tabs together on both sides of the container, pull upward and off. • Twist the center lid plug to fasten or remove. 2 Liter Polycarbonate container The one piece lid is easy to clean and easy to put on and take off. Figure C (Note: Brand new lids are a little stiff. This is temporary.
PAGE 8
I nstructions How to operate your Blending Station® using the six Pre-Set Programmed buttons. The following is the basic factory settings of the six PRE-SET buttons (your machines PRE-SET buttons may be different if your Blending Station was programmed specifically for your business). • Button 1: (:15) Blends thin drinks with just juice and ice. This program will quickly ramp to a high blending speed for 15 seconds. • Button 2: (:20) Blends light coffee drinks.
PAGE 9
1. Follow steps one through three of ‘Using The Pre-Set Programmed buttons’ section on page 14. 2. The speed of the motor can be changed with: Blade Agitator Assembly. Use caution when handling the blade; it is sharp. When inserting the blade assembly through the container bottom, grip the blades with a soft cloth, align the flat sides of the blade assembly with the flat sides of the container. Place the retainer nut back on the inserted blade assembly and tighten clockwise. Do not force.
PAGE 10
P arts List Item# Part #752 2 liter - Container without lid assembly or blade assembly #755 2 liter - Lid plug #756 2 liter - Container, blade assembly & lid assembly #1191 2 liter - 2-piece lid assembly #1192 2 liter - Lid only (no plug) PLS145 2 liter - 1-piece non-latching rubber lid #1159 1.5 liter - Lid plug #15502 1.5 liter - Container only #15506 1.5 liter - Container, blade & lid assembly #15507 1.
PAGE 11
C are and Cleaning Care Note Container Do not let mixtures, liquids and food products dry within the container. Rinse throughout use. Drying product may lock around the blade and weaken/tear the bearings seal when restarted. Do not place containers in the freezer. Extremely low temperature combined with hot ingredients and/or the immediate rapid action of the blade may crack the container. 1. To clean: Fill pitcher 1/4 full with warm (43˚C) water and add a couple drops of dish soap.
PAGE 12
T roubleshooting Top nine problems you can fix on your own: 1. Problem: • Display Panel reads THERMAL SENSOR FAILURE 2. Problem: • loud noise from blender container blade area • container blades do not spin • increased vibration • leaking from bottom of container Solution #1: Turn the machine off and on again to reset the programming Solution #2: Contact your dealer or local distributor. Solution #1: Broken or worn Drive Socket. Replace (Item # 802). Instructions are included with part.
PAGE 13
S pecifications Blending Station® On-Counter: Height of unit closed: 54.56 cm • Shipping weight: 9.534 kg Dimensions 54.56 cm H x 23.45 cm W x 25.86 cm D Blending Station In-Counter: Height of unit above counter: 44.45 cm closed Depth of unit below counter: 14.4 cm • Shipping Weight: 8.172 kg Dimensions: 45.03 cm H x 23.45 cm W x 25.86 cm D NOTE: For In-Counter Installation refer to pages 8-10.