Operating instructions

10 VITA SPA DUET
JETS, AIR CONTROLS & VALVES
Jets
All spa jets are individually engineered
to provide a unique hydro-massage.
Depending on the model, your spa will have
a combination of the following jets:
Directional Therapeutic
(200, 300, and 400 Series Wave Style):
Positioned to focus on large muscle groups,
these jets deliver a concentrated, high
volume stream of water for a deep massage.
Each jet is fully adjustable, allowing users to
set the water  ow to the most comfortable
setting. The nozzle can be rotated to target
sore muscle areas.
Rotational or Spinning Jets
(200, 300, and 400 Series Wave Style):
Positioned to focus on muscle tension
zones, these jets deliver a spinning water
stream for a gentle, pulsating massage.
Each jet is fully adjustable, allowing users to
set the water  ow to the most comfortable
setting.
Swim Jet( non-adjustable):
Positioned to create overall water
circulation, this multi-purpose, high volume
jet provides whirlpool action throughout
the entire spa.
Euro Jets:
Positioned in the foot well or shoulder areas
of the spa, these jets deliver a penetrating
massage to dissolve tension. This jet may be
the entry point for ozone produced during
the automatic  ltration cycles, and, as such,
is not adjustable.
Note: Ozone production is activated when
the low speed pump is activated.
Many full sized jets are adjustable from a fully
open to closed position. It is very important
that you NEVER SHUT ALL FULL SIZED JETS
OFF AT ONE TIME! WHEN EXITING THE SPA,
OPEN ALL CLOSED JETS.
Cleaning or Replacing Jets
Hard water can cause calcium/mineral
buildup that can restrict or bind the jets. A jet
consists of a face plate and a nozzle. Rotate
these parts weekly and remove/clean monthly
to ensure free movement.
NOTE: It is not necessary to drain the spa to
clean or remove the jets.
Rotating the jet face plate and nozzle
• Rotate the jet face left and right
(open and closed).
• Return the face plate to the full open
position.
• Turn the jets on to high speed.
• Twist the nozzle left and right.
• Rotate the nozzle in the socket.
NOTE: If the jet insert disengages from the
spa housing, see steps to reinstall below.
Cleaning the jets
To remove the jet insert, use the palm of your
hand to exert pressure on the face of the jet.
Turn counterclockwise until the jet ‘clicks’.
Gently pull the jet assembly from the housing.