Operating instructions

17 VITA SPA DUET
the 6 minute wait period). The cycle will begin
at 9:00 PM and will repeat beginning at 9:00
AM. Each cycle will run for the prescribed
number of hours.
Changing Filter Cycle Duration
The duration of a  lter cycle can be set in one
hour increments of 1- 8. For example, a 2
hour cycle will complete once every 12 hours
for a total of 4 hours per day. The amount of
time needed to  lter you spa will depend on
usage and ambient conditions.
You will need to program you  lter cycles
based upon your personal use.
To change the duration of the  lter cycles
touch the ‘TEMP’ pad and then touch the
‘JETS’ pad. Touch the ‘TEMP’ pad to adjust
the cycle duration to the desired setting. After
each press, the duration of the cycle will be
displayed in the LCD window as follows:
F1 1 Hours for each cycle, 2 hours per day
F2 2 Hours for each cycle, 4 hours per day
F3 3 Hours for each cycle, 6 hours per day
F4 4 hours for each cycle, 8 hours per day
F5 5 hours for each cycle, 10 hours per day
F6 6 Hours for each cycle, 12 hours per day
F7 7 Hours for each cycle, 14 hours per day
F8 8 Hours for each cycle, 16 hours per day
To exit the  lter-set procedure, touch ‘JETS’.
The LCD window will display the current water
temperature.
If a change is made to the duration while the
spa is in a  ltration cycle, it will take e ect
immediately. If the change is made outside a
 ltration cycle, it will take e ect at the start of
the next scheduled cycle.
NOTE: When power to the spa is denied
(disconnect, power outage), the controls
may revert to the default factory settings.
temperature drops below 45°F (7.2°C).
The selected mode will be displayed in the
LCD window of the control panel.
When in Standard mode, the letters ‘ST’
are displayed beie y, followed by the water
temperature. When in Economy mode, the
letters ‘EC’ are
displayed alternately with the
water temperature.
When in Sleep mode, the letters ‘SL’ are
displayed alternately with the water temperature.
Setting the Time and Filtration Cycles
You can decide when your  lter cycles start
and you also have choices on how long they
run.
Preset Filter Cycles. The spa control system
is designed with two  lter cycles. The  rst
 lter cycle turns on 6 minutes after power is
supplied to the spa. The second  lter cycle
turns on 12 hours later. Filter cycles are pre-set
for a two hour duration.
Note: To properly clean and maintain spa, a
total  lter time of at least two hours per day
is recommended. If an ozonator is installed,
4 hours is recommended.
Changing Filter Cycle Start Time
The start/stop times of the  lter cycle begin 6
minutes after the spa set time is established.
Set time is based on the time of day that
the spa is powered up. Set time may only be
changed by disconnecting power from the
spa and re-connecting it at the desired start
time. For example, if you want the  lter cycle
to begin at 9:00 PM,turn o the spa breaker
and turn it back on at 8:54 PM (remember