Owner`s manual

1. Press and hold the “PROG” button for 5
seconds to enter the programming mode.
“AH” will flash on the display. If you are
already in the programming mode, go
directly to step 2.
2. Press “PROG” three times to show the
filter cycle schedule. Notice the flashing fil-
ter icon.
3. Press “UP” and “DOWN” to change the
hour.
4. Press “JET” button to change the filter
from “-” (Off) to “F” (ON) or vice versa.
5. Wait 30 seconds or press the “LIght”
button to exit the programming mode.
USING YOUR SPA
A. D I S PLAY ING TIME OR TEMPE RAT URE
Pressing the “PROG” button will switch the
display between current time and current
water temperature.
B. WATER JET THERAPY
Your spa is equipped with one or two ther-
apy pumps that can be activated as follows.
Jet Button:
SINGLE PUMP SYSTEM
1. Press “JET” to activate the Relaxation
Therapy mode.
2. Press “JET” to activate the Power Therapy
mode.
3. Press “JET” to turn pump off
DUAL PUMP SYSTEM
1. Press “JET” to activate the Relaxation
Therapy mode.
2. Press “JET” to activate pump#1 Power
Therapy mode.
3. Press “JET” to activate pump #2 Power
Therapy mode.
4. Press “JET” to de-activate pump #1.
5
.
Press “JET” to de-activate pump #2.
Note that for safety, all jet modes will auto-
matically turn off after 30 minutes.
Reactivate any therapy mode as indicated
above.
In the ECONOMY mode, the pump and
heater will only come on during pro-
grammed hours. (See “Setting Filtration
Hours”). Note that, if at the end of filtration
cycle the water is not at the chosen tem-
perature, the pump and heater will not con-
tinue to run until that temperature is
reached. This mode is used for energy con-
servation, the same way you would control
your heat or air conditioning in your house.
The clock icon will be displayed when in
ECONOMY mode.
To switch to the ECONOMY mode:
1. Press and hold the “PROG” button for 5
seconds to enter the programming mode.
“AH” will flash on the display.
2. Press “UP” or “DOWN” button to
change between ECONOMY (ECO) and
AUTO HEAT (AH). Observe the clock icon
when in ECONOMY mode.
3. Wait 30 seconds or press “Light” button
to exit the programming mode.
C. SETTING CURRENT TIME
1. Press and hold the “PROG” button for 5
seconds to enter the programming mode.
“AH” will flash on the display. If you are
already in the programming mode, go to
step 2 directly.
2. Press “PROG” one more time to show
the Hour.Observe the flashing clock icon
and PM indicator. No indicator means AM.
3. Press “UP” or “DOWN” to select the
current hour.
4. Press “PROG” one more time to show
the minutes.
5. Press “UP” or “DOWN” to select the
current minute.
6. Wait 30 seconds or press the “Light”
button to exit the programming mode.
D. SETTING FILTRATION CYCLES
Filtration cycles have been preset at the fac-
tory from 8 AM to 10 AM and from 4PM to
6 PM. They can be changed as follows.
PAGE 15