Owner`s manual

SYMPTOM
PROBABLE CAUSE
SOLUTION
Spa inoperative
Power Failure outside of Spa
Oleck power source Breaker and
GFCI; Reset breaker / GFa. Call
Electrician if it will not reset.
Spa side locked
Lockout light is flashing .
Unlock.
Display: I-llLI
Overheat
Let water temperature cool down
to 1O4F and reset by holding
HEATER switch for 5 seconds, or
until display returns to normal. H
HII.J message returns, call for ~re.
Display: BJ2P
Blower /Pump purge
Normal if this occurs twice daily.
H not, reset system by turning
power to the spa off, and back on.
Display: SS=O;
SS=S; LS=O; LS=S
Multiple
Call for Service.
Water not hot
Improper setting
Set heater to desired setting and
start the mter by holding
FILTER switch down for 5
seconds to start a 6-hour period.
Not a heat dar
O\eck heat day to make sure
today is a heat day.
If these tMJ solutions do not solve the problem, call for service.
NOTE: Extreme electrical noise problems such as power surges or nearby electrical storms could dis-
turb the Selectron's mternal computer in the same way as your home computer. H you suspect a prob-
lem with the computer because of a strange display or a performance that is not normal, before call-
ing for service, disconnect the spa by turning off your breaker. Turn the power back on and the
Selectron will automatically clear its memory and return to its original factory settings. This is similar
to pushing the "reset" button on your home computer.
VITA INTERNATIONAL
2320 NW 147th Street
Miami, Florida 33054