Owner`s manual

when the next switch is touched.
8. Starting Filters
Touch and hold the FILTER switch for 5 sec-
onds. The FILTER light will then come on and
the display will show "F=6H", meaning that
the filter will run for 6 hours, clearing up your
tap water. Afterwards, the filter hours will be
7am to 9am and 4pm to 6pm each day unless
you reset the filter hours for your particular
needs. H you wish to stop the filter in less than
6 hours, hold the FILTER switch again for 5
seconds or until the display shows "F=O" .The
filter will continue to run, however, if the
heater is still on.
NOTE: For best results, read each step carefully
and entirely before proceeding to the next.
I) FILL YOUR SPA
Wipe the interior of the spa with a damp, soft
cloth to remove any residue that may be <?n the
surface. Fill with a garden hose. As the spa is fill-
ing, check in the equipment access area for any
leaks. On occasion, it may be necessary to hand
tighten a union fitting that may have come
loose during transit. Also check that the gate
valves are pulled out to the open position and
that the hose bib is closed. Continue to fill to
the water level line.
c. Stardng Heater
Mter the filter has run for 15 seconds, the
heater will come on and heat the water until it
reaches a temperature of 102 degrees. If this
takes longer than 6 hours, the filter will con-
tinue nmning. (Whenev~r the water reaches
the set temperature and heater turns off, the
filter will run one extra minute to cool the
heater element.)
NOTE: H your water is extremely' hard, it is
preferable to fill the spa halfway with hard water
and the rest with softened water. Never fill the
spa entirely with softened water.
2) GEmNG STARTED
.OTE: H water has not reached the set tem-
perature level after a filtration cycle, or after
you have used the spa, the filter and heater
will stay automatically on until the set tem-
perature has been reached.
3) ADJUmNG SETTINGS
A. Changing Temperablres
Your spa has been preset to heat the water to
102 degrees eadt time the filter nms. Toudt
the TEMP switdt once to display the actual
water temperature; toudt again to disp!ay the
set temperature. While the light is flashing,
you may decrease or increase (up to 104)
degrees) the set temperature by using the UP
and DOWN switdtes. H the heater is on and
you wish to turn it off, simply reduce the set
temperature below the actual temperature.
Illustration 1
A. Setdng 11mer
Touch TIME switch once to display time, then
touch switch again to enter the time set mode .
{Note that the light is flashing over the TIME
switch and the display is showing the day
number). Use UP and DOWN switches to set
present day of week (Sunday is considered
day number 1). Touch TIME switch again to
show the hour, then use UP and DOWN
switches to set the current hour. Be careful to
observe the AM /PM indicator in the display
window. Touch TIME switch once again to
show and set the current minute. The display
will automatically return to normal and the
light will stop flashing after 20 seconds, or
B. Changing Fiber Hours
Touch the FILTER switch once to enter the fil-
ter hour set mode. While the FILTER light is
flashing, use the UP and DOWN switches to
review each hour of the day. H an wFw is dis-
played beside the hour, the filter will run dur-
ing that hour each day. Use repeated touches
of the FILTER switch to add or remove the
wFw beside each hour. H the filter is running {1]