IMPORTANT SAFETY INSTRUCTIONS READ ENTIRE MANUAL BEFORE INSTALLING SPA. PLEASE SAVE THIS MANUAL. OWNER’S MANUAL L-60 Controller & Pack These instructions apply to: S & SE PACKS DM INDUSTRIES, LTD. 2320 N.W.
NOTE: For best results, read each step carefully and entirely before proceeding to the next. FILLING YOUR SPA Wipe the interior of the spa with a damp, soft cloth to remove any residue that may be on the surface. Fill with a garden hose by inserting the nozzle of the hose in the filter inlet. (After filling is complete, remember to put the filter cartridge in place prior to starting the spa.) As the spa is filling, check in the equipment access area for any leaks.
OPERATING INSTRUCTIONS A. DISPLAYING TIME OR TEMPERATURE Pressing the "PROG" button will switch the display between current time and current water temperature. B. SETTING TEMPERATURE FOR A DAY. 1. Press the "PROG" button to display water temperature. 2. Press the "UP" or "DOWN" arrow to select the desired temperature. NOTE: this setting is only valid for the rest of the day. Go to section SETTING PERMANENT TEMPERATURE below to make permanent changes. C.
OPERATING INSTRUCTIONS The heater will come on as needed during filtration hours to maintain the water temperature. Note that filtration will also be provided during the heating cycles. E. HEAT DAYS If your spa is located in a weekend home, or if your schedule allows utilization of the spa only on certain days of the week, you may decide for energy conservation reasons to lower the water temperature on the days you will not use the spa. Your spa is pre-programmed from factory and set to "All" days "hd=A".
OPERATING INSTRUCTIONS ADVANCED FEATURES SETUP Note that at any point in the sequence, press any other button to exit programming. Alternately, the display will return to normal if no button is pressed within 10 seconds. SETUP ("SU") Enter programming menu by holding "PROG" button for 5 seconds. Then press "PROG" to sequence to "SU" on the display. To access the advances features menu, while in the "SU" display, hold the "PROG" button for 10 seconds.
PROGRAMMING CHART DM INDUSTRIES I.C.S. PROGRAMMING CHART PROG PROG 3s 8s Press hold button AUX For Blower option for 8 seconds LIGHT Underwater LEDs Self Test (2 min.
MAINTENANCE LOG Use this section to keep a record of when you perform any maintenance on your spa.
MIAMI FLORIDA DM Industries, Ltd., 2320 Northwest 147th Street, Miami, Florida 33054 Email: customercare@dmindustries.com and techhelp@dmindustries.com REV.