Owner`s manual

PAGE S-2
A. DISPLAYING TIME OR TEMPERATURE
Pressing the "PROG" button will switch the display
between current time and current water
temperature.
B. SETTING TEMPERATURE FOR A DAY.
1. Press the "PROG" button to display water
temperature.
2. Press the "UP" or "DOWN" arrow to select the
desired temperature.
NOTE: this setting is only valid for the rest of the
day. Go to section SETTING PERMANENT
TEMPERATURE below to make permanent
changes.
C. PROGRAMMING MENU
Press and hold for five seconds to enter the
programming menu.
Note that at any point in the sequence; press any
other button to exit programming. Alternately, the
display will return to normal if no button is pressed
within 10 seconds.
D. SELF - DIAGNOSTIC TOOL
Your spa controller offers the latest state-of-the-art
diagnostic tool. To start the test, press and hold
"PROG" for 5 seconds. The display will show
"dISC". Initiate the self-diagnostic test by pressing
the "UP" button. This test will run the equipment
sequentially for 2.5 minutes. Use the "DOWN"
button to cancel the self-test at any time. Once the
test is completed, the message "GOOD" will be
displayed if your spa operates properly. If a problem
is found, the malfunction code will be displayed.
Please contact your dealer for corrective action.
D.AUTO HEAT AND ECONOMY MODE
(Spas with 2 speed filtration pump and no
circulation pump).
Spas with 2-speed filtration pump have been
designed to operate in two heater control modes:
AUTO HEAT ("AH") and ECONOMY ("ECO"). In
the AUTO HEAT mode, the pump and heater will
turn on whenever the water temperature falls 1
degree below the chosen temperature.Your spa has
been preset to start upon activation in the AUTO
HEAT mode. The spa water will be automatically
heated to the temperature you choose or to the
preset temperature of 102 F. Your selected water
temperature and filtration will be maintained
automatically 24 hours a day. The spa water will
heat about 1 to 3 degrees F per hour for 110 Volt
system and 3 to 5 degrees F for 220 Volt systems.
The maximum temperature is set at 104 F. The
pump hi-speed therapy mode can be activated
during those cycles. The heater will stay on if
needed to bring up the water temperature.
Note: that for 110 Volt spas, the heater will turn off
when you turn on any therapy pump or blower.
In the ECONOMY mode, the pump and heater will
only come on during programmed hours.This mode
is used for energy conservation, the same way you
would control your heat or air conditioning in your
house.
To switch to the ECONOMY mode:
1. Press and hold the "PROG" button for 5
seconds until "dISC" is displayed.
2. Press the "PROG" to display "AH" or "ECO".
3. Use "DOWN" arrow to select the "ECO" setting
if necessary or the “UP” arrow to select “AH”.
4. Press the "DOWN" button one more time to
"-" display the hour and the cycle showing either
"-" for off or "F" for on.
5. Press the "UP" arrow to cycle through the
selected hours of the day.
6. Press the "DOWN" arrow to select the cycle
showing either "-" for off or "F" for on.That
will represent the filtration cycle desired
for that hour.
7. Press the "PROG" button to continue the
programming mode or any other button to
exit.
OPERATING INSTRUCTIONS