Owner`s manual

PAGE S-3
OPERATING INSTRUCTIONS
The heater will come on as needed during filtration
hours to maintain the water temperature. Note
that filtration will also be provided during the
heating cycles.
E. HEAT DAYS
If your spa is located in a weekend home, or if your
schedule allows utilization of the spa only on
certain days of the week, you may decide for energy
conservation reasons to lower the water
temperature on the days you will not use the spa.
Your spa is pre-programmed from factory and set
to "All" days "hd=A". To choose different
temperatures for different days of the week, follow
the following steps:
Example: Let's assume that you have selected 100
degrees F as your desired temperature in the
"Setting Permanent Temperature" procedure and
Sunday as "1." You would now like to lower the
water temperature to 80 degrees F on Mondays,
Tuesdays, and Wednesdays.
1. Hold down "PROG" for 5 seconds, "dISC" will
appear.
2. Press "PROG" to sequence to "hd=A" on the
display.
4. Press "UP/DOWN" buttons to select the desired
heat day. ( "hd=2" (Monday)
5. Press "PROG" to display temperature. Hold down
"DOWN" button to lower temperature to 80
degrees F.
Repeat steps 2, 3, & 4 to do the same for Tuesday
and Wednesday. Normal display will resume after
10 seconds.
SETTING PERMANET TEMPERATURE:
1. While in the programming menu, press "PROG"
to sequence to the display temperature.
2. Press UP/Down to select desired temperature.
NOTE: See procedure above if you would like to
choose different temperatures for different days of
the week.
F."F" FAHRENHEIT OR "C" CELSIUS DEGREES
Your spa has been preset to show the temperature
in Fahrenheit "F" degrees. If you desire, you can
change to Celsius "C" degrees (while in the
programming menu) by pressing the UP/DOWN
button to switch back and forth between "F" and
"C" mode.
G. HOUR AND CALENDAR SETTING.
While in the programming menu ("PROG" pressed
for 5 seconds), press "PROG" to sequence through
the following displays to set the hour and calendar.
Hour Display- "H=24". Allows you to cycle between
12 and 24 hour time features. Use UP button to
select 24 hour display, "H=24" or the Down button
to display "H=12"
Hour - "12:00" notice hour flashing. - Use UP/DOWN
buttons to change the hour to the current time
"12:00".This should not be necessary unless the spa
has not been powered up for several weeks.
Minutes - "12:00" notice the minutes flashing.
Use UP/DOWN buttons to change the minutes to
the current time
Month - "1 1" notice the month flashing.
Use UP/DOWN buttons to change the month.
Date - "1 1" notice the day flashing.
Use UP/DOWN buttons to change the day.
Year - "2007" notice the year flashing.
Use UP/DOWN buttons to change the year
INVERTING DISPLAY
The topside display can be inverted to allow easier
reading from inside the spa. To do so, while in the
programming menu ("PROG" pressed for 5
seconds), press "PROG' to sequence to "FLIP" on
the display. Use the UP or DOWN buttons to
invert the display back and forth.