Owner`s manual

Now that your spa is drained out and cleaned, you are ready to reﬁll it. To reﬁll the

spa and put it back into operation, follow the steps listed below:

! 1.! Close the drain bib or on Reﬂections models, push the plug in and turn clockwise to the original

! ! position. Remove the hose.

!2.! Begin ﬁlling the spa.

! 3.! Keep ﬁlling the spa until it is at the desired level.

! 4.! Turn power on to the spa.

! 5.! Check spa for water ﬂow. IMPORTANT! If water is not moving through your spa when

! ! the pumps are running, you may have an air lock. Continued operation in this situation

! ! will damage internal components of the spa, such as seal sets, motors, and heating

! ! elements. Temporarily remove the ﬁlter(s) and turn on the pumps for a few sections. This will

! ! usually get rid of the airlock. If the problem persists please call our service department for

! ! further guidance that can be rendered via the phone. They can be reached at 513-528-8878.

! ! Airlocks are common in spas so don’t panic if you get one. It is a minor inconvenience that is

! ! usually very easy to dispose of.

! 6.! Reset thermostat and ﬁltration settings.