Owner`s manual

61 Owner’s Manual
English
COMMON HARDWARE PROBLEMS
Problem
System not
operating
Heater not
operating
Water not clean
Abnormal
water usage
Overheating
Low water ow
from jets
Noisy pump
and motor
Usual Cause
- House circuit breaker tripped or
in OFF position
- Water level too low
- Heater mode not selected
- No power to heater
- Heater not operating
- Jets are closed
- Clogged or blocked oor suction
or skimmer
- Filter clogged (dirty)
- Poor water chemistry
- Insucient ltering time
- Improper maintenance
- High content of solids in water
- Excessive evaporation
and/or splashing
- High ambient temperature
- Operating in FILTER mode-low speed
- Clogged or blocked suction or skimmer
- Dirty lter
- Jets in OFF position
- Slice valves closed
- Clogged oor suction or skimmer
- Low water level
- Damaged or worn motor bearings
Solution
- Reset circuit breaker on house
breaker panel
- Add water to reach ll line
on Weir door
- Open all jets
- Refer to temperature/heater
functioning.
- Check house circuit breaker
- Contact dealer
- Clean oor suction/skimmer.
Remove blockage
- Clean or replace
- See Maintenance section
- Run ltration mode longer
- Contact dealer
- Use clarier or drain and rell spa
- Use spa cover and rell
as necessary
- Contact dealer
- Select hi-speed jets
- Clean oor suction/skimmer.
Remove blockage
- Clean or replace
- Open jets
- Contact dealer
- Clean oor suction/skimmer
- Add water to normal water level
(15cm below lip)
- Contact dealer