Owner`s manual

13 VITA SPA
ENGLISHFRANÇAIS
Cleaning the jets
To remove the jet insert, use the palm of your
hand to exert pressure on the face of the jet.
Turn counterclockwise until the jet ‘clicks’.
Gently pull the jet assembly from the housing.
To clean the jet insert and housing, use a
pressurized hose and spray the inside of
the jet housing. Soak the jet in a diluted spa
cleaning solution, rinse. Wipe the inside of the
housing to remove any debris.
To reinstall the jet, line up the tab on the
backside of the barrel with the groove in the
body. Use the palm of your hand to gently tap
the jet until it snaps into position.
Air Controls
The intensity of the jet action can be
controlled by altering the amount of air
injected with water through the jets. Your spa
has 2 to 4 air controls located on the lip of
the spa. Each control activates air to speci c
jets in the spa allowing you to create various
combinations and levels of jet action to
suit individual preferences. Turn the control
counter- clockwise to turn the air o and
clockwise to turn air on.
NOTE: Air controls should be closed
during heating cycles for maximum
energy e ciency.
NOTE: At the start of a  ltration cycle,
the Champagne Air System is activated
to purge the lines and ensure complete
 ltration. Ensure that at least one air control
is always fully open.
On / O Valve: Turns on or shuts o the  ow
of water to multiple jets or the waterfall.
Diverter Valve: Diverts water from one set
of jets to another. The diverter valve should
be tested weekly to clean the lines and to
help prevent debris from building up.
NOTE: The diverter and on / o valve(s)
should be cleaned regurally. Remove the
handle by pulling upward and rocking it
back and forth, unscrew the cap and pull the
valve stem out. To clean the valve stem and
housing, use a pressurized hose and spray the
inside of the valve housing. Soak the valve
stem in a diluted spa cleaning solution, rinse.
Wipe the inside of the housing to remove any
debris.