Owner`s manual

18 VITA SPA
ENGLISH FRANÇAIS
The set temperature of your spa may easily
be increased or decreased at any time using
the ‘TEMP’ pad. Press the ‘TEMP’ pad; the
set temperature will be displayed in the
LCD window. The next touch of ‘TEMP’ will
change the set temperature either up or
down 1°F (0,5°C). If you want to increase
the temperature and the displayed indicates
the temperature was increased by 1°F (0,5°C),
continue to press the ‘TEMP’ pad until the
desired set temperature is reached.
If you want to decrease the set temperature
and the LCD indicates that the temperature is
increasing, STOP. Wait a few seconds until the
actual temperature is displayed. Then press
the ‘TEMP’ pad again. The set temperature
will be displayed. Press it again and the set
temperature will decrease by 1°F (0,5°C).
Continue pressing the ‘TEMP’ pad until the
desired set temperature is reached.
If the spa is set in Standard mode or in a
 ltration cycle, increasing the set temperature
may result in activating the heater. Decreasing
the set temperature will turn the heater o .
When the heater is operating, the LCD below
the ‘HEAT’ icon will be lit.
Pump 1
Touch the ‘JETS’ pad to activate the primary
 ltration pump. The sequence of the jet action
is:
1 touch = Low therapy jets
2 touches = High therapy jets
3 touches = O
The low speed operation of Pump 1 is timed
to automatically turn o after two hours
of operation. The high speed operation of
Pump 1 is timed to automatically turn o
after 30 minutes of operation.
User’s Pads
User’s Pads are the buttons located on the
topside control panel and are used to program
various spa functions (i.e., turn on spa light, set
temperature, etc.). The following table de nes
the buttons:
Pad Use
Temp
• Decrease temperature
• Increase temperature
• Switch modes
• Change  ler cycle durations
Lght
• Turn internal spa light on or o
• Switch modes
Jets
• Activate therapy pump
• Set duration of  lter cycles
Blower
• Activate Champagne Air
System
Temperature
The maximum set temperature is 104°F (40°C)
and the minimum set temperature is 80°F
(26°C). The current water temperature or, if
the pump has not been running, two dashes,
will show on the display. If dashes are
displayed, you must  rst start the pump by
pressing the PUMP 1 pad. Wait until the water
temperature is displayed (approximately 2
minutes).