Owner`s manual

23 VITA SPA
ENGLISHFRANÇAIS
Temperature
The maximum set temperature is 104°F (40°C)
and the minimum set temperature is 80°F
(26°C). The current water temperature or, if
the pump has not been running, two or three
dashes, will show on the display. If dashes are
displayed, you must  rst start the pump by
pressing the ‘JETS 1’ pad.
Wait until the water temperature is displayed
(approximately 2 minutes).
The set temperature of your spa may easily
be increased or decreased at any time using
the ‘UP’ or ‘DOWN’ pads. When either of these
pads is touched, the set temperature will be
displayed in the LCD window. Each successive
touch will change the set temperature 1°F
(0,5°C) in the chosen direction. After 3 seconds
the LCD will automatically display the water
temperature or dash lines.
If the spa is set in Standard mode or in a
 ltration cycle, adjusting the set temperature
may result in activating the heater.
When the heater is operating, the heat icon
will be displayed in the LCD.
JETS 1
Touch the ‘JETS 1’ pad to activate the primary
 ltration pump. The sequence of the jet action is:
1 touch = Low therapy jets
2 touches = High therapy jets
3 touches = O
JETS 2
Touch the ‘JETS 2’ pad to activate the therapy
pump. The sequence of jet action is:
1 touch = Low therapy jets
2 touches = High therapy jets
3 touches = O
User’s Pads
User’s Pads are the buttons located on the
topside control panel and are used to program
various spa functions (i.e., turn on spa light, set
temperature, etc.). The following table de nes
the pads:
Pad Use
UP
• Increase temperature
• Change time settings
• Used in alternate programming
sequences
Down
• Decrease temperature
• Change time settings
• Used in alternate programming
sequences
Time
• Used in alternate programming
sequences
• Exit programming
• View the Time
Prog
• Switch modes
• Set time and  ltration cycles
Light
• Turn all spa light on or o
Air
• Blower / Champagne Air
System
• To activate the INVERSION
feature
Jets 1
• Activate primary  ltration pump
•Used in alternate programming
sequances
Jets 2
• Activate therapy pump