Owner`s manual

26 VITA SPA
ENGLISH FRANÇAIS
After pressing the ‘PROG’ button to enter
the end time of the  rst  lter cycle, you
should now see the ‘PROGRAM’, ‘FILTER 2’,
and ‘START TIME’ icons on the LCD display
window. Adjust the hours and minutes for
the start time of the second  lter cycle as
described above.
After pressing the ‘PROG’ button
to enter the start time of the second  lter
cycle, you should now see the ‘PROGRAM’,
‘FILTER 2’, and ‘END TIME’ icons on the LCD
display window. Adjust the hours and minutes
for the start time of the second  lter cycle as
described above.
After pressing the ‘PROG’ button to enter the
end time of the  lter cycle, the new  ltration
times will be saved into the system and
the LCD window will revert back to display
the current water temperature. Pressing
the ‘TIME’ button at any time during the
above programming sequence will save the
values entered up to that point and exit the
programming sequence. To set the spa for
continuous  ltration, set the start and end times
of the  rst  lter cycle to the exact same time.
Note: To properly clean and maintain spa,
a total  lter time of at least four hours per
day is recommended. If an ozonator is
installed, 6 hours is recommended.
Clean Up Cycle
After periods of heavy use, you can manually
start a clean-up cycle by turning Pump 1 on in
low speed. The pump will operate for 2 hours
and then automatically turn o . The heater
will also operate during this period if the
controls are set in the Standard mode.
NOTE: Activating the low speed of Pump 1
for a clean-up cycle will initiate  ltration,
but not ozone production, unless the spa
Standby mode. At the beginning of each
 ltration cycle, the other equipment in the
spa will turn on for 30 seconds to purge all
plumbing lines and ensure complete  ltration.
Changing Filter Cycles
The control system allows you to adjust the
start time and duration of each  lter cycle
independently to best suit your schedule. The
amount of time needed to  lter your spa will
vary depending upon usage and ambient
conditions, but a total  lter time of at least
four hours per day is recommended to properly
clean and maintain the water.
To initiate the programming sequence to
change the  lter cycles, press ‘TIME’, ‘PROG’,
‘PROG’, and ‘PROG’ within 3 seconds.
If you are setting the  lter cycles as a
continuance from setting the time then
proceed to the next paragraph.
press ‘PROG’
You should now see the ‘PROGRAM’, ‘FILTER
1’, and ‘START TIME’ icons on the LCD display
window. The hour digit(s) will be  ashing on
the LCD window. Press the ‘UP’ or ‘DOWN’
button to advance the hours up or down to
the desired set point. Press the ‘PROG’ button
to enter the time hour. The minute digits will
now be  ashing on the LCD window. Press
the ‘UP’ or ‘DOWN’ button to advance the
minutes up or down to the desired set point.
Press the ‘PROG’ button to enter the time
minutes.
You should now see the ‘PROGRAM’, ‘FILTER 1’,
and ‘END TIME’ icons on the LCD display
window. Adjust the hours and minutes for
the end time of the  rst  lter cycle as
described above.