Owner`s manual
Table Of Contents
- Cover
- Acrobat Viewing Instructions
- Table of Contents
- Table of Contents-Close Up
- Owner's Record-(Print for your records)
- Pg01: President's Message
- Pg02: Important Safety Instructions
- Pg03: Do's and Don'ts
- Pg03:Warnings
- Pg04: Installation Instructions
- Pg05: Clearances
- Pg06: Electrical Requirements& Installation 1
- Pg07: Electrical Requirements& Installation 2
- Pg08: Electrical Requirements& Installation 3
- Pg09: Electrical Requirements& Installation 4
- Pg10: Electrical Requirements& Installation 5
- Pg11: Cover Installation
- Pg12: Operating Instructions
- Pg13: Using Your Spa
- Pg14: Special Features 1
- Pg15: Special Features 2
- Pg16: Advance Features
- Pg17: Jet Operation 1
- Pg18: Jet Operation 2
- Pg19: Jet Operation 3
- Pg20: VitAroma
- Pg21: Water Purification System
- Pg22: Spa Maintenance 1
- Pg23: Spa Maintenance 2
- Pg24: Spa Maintenance 3
- Pg25: Spa Maintenance 4
- Pg26: Water Quality & Maintenance
- Pg27: Important Water Maint. Procedures
- Pg28: Balancing Spa Water 1
- Pg29: Balancing Spa Water 2
- Pg30: Water Maint. Do's & Don'ts
- Pg31: Spa Water Troubleshooting 1
- Pg32: Spa Water Troubleshooting 2
- Pg33: Diagnostic & Troubleshooting
- Pg34: LCD Display Glossary
- Pg35: Maintenance Log (for Printing)
- Mfg Address & Phone Numbers

PAGE 32
SYMP TO M
A l g a e
Eye Irritation
Skin Irrita t i o n / R a s h
Stains
S c a l e
PR O BA BLE CAUSE
High pH
Low free chlorine/bromine
Low pH
Insufficient free available
c h l o r i n e / b r o m i n e
Unsanitary/polluted water.
Chlorine/bromine level too high
(above 5ppm FAC ) .
pH or total alkalinity too low.
High iron or copper in water
s o u r c e .
Too much calcium dissolved in
water pH.
SO LU T I O N S
Shock with “POTA S S IUM PE R OXY
M O N O S UL FAT E ”, adjust pH.
Shock with “POTA S S IUM PE R OX Y
M O N O S UL FAT E ”, maintain sanitizer at
recommended level.
Raise pH with “PH - UP ”.
Shock with “POTA S S IUM PE R O XY
M O N O S UL FAT E . "
Maintain recommended sanitizer
residual at all times; super-chlorinate.
Allow chlorine/bromine level to drop
below 5 ppm before using spa.
Adjust pH and total alkalinity; use
sequestering agent; drain and clean
with appropriate product.
Use sequestering agent for metals;
adjust water
Adjust total alkalinity and pH levels
by adding the appropriate sodium
bisulfate product; with concentrated
scale deposits, drain the spa, clean the
liner (as outlined in Liner Clean Up),
refill the spa and balance the water.
SPA WAT ER TROUBL E SHOOT ING