Operating instructions

TIMER OPERATION
ALWAYS sequence your spa back to function
No.1 (heater-low speed pump) after spa use.
Program timer 3 to 4 hours daily to maintain
water flltratiQn and desired temperature. Set
timer to come for one hour before and one
hour after your intended use, plus two addi-
tional hours. For instance, in you intend to
use your spa between 6 and 8 p.m., set timer
between 5 and 6 p.m. and between 9 and 10
p.m. Additionally. set timer for one hour at 9
a.m. and 2 p.m.
ACCESSORY #2 BUTTON:
Turns the light ON and OFF. It does hot
interact with heater .
SYSTEM INDICATOR LIGHT
Indicates that the system button has been
pushed and the system is under manual
control.
ELECTRONIC THERMOsTAT
Controls the temperature of the spa. Set
thermostat to desired setting and water
temperature and filtration will be maintained.
Heater and low speed pump will. turn on as
needed on both 12Ov or 240\1 systems.
FREEZE PROTECTION is provided by setting
the thermostat at an adequate temperature
level.
3.4 FEATURES AND FUNCTIONS -LX SERIES
3.4.1 SPA SIDE CONTROL
The spa side panel includes 4 ON/OFF
buttons: SVS (low speed pump), JET (high
speed pump), Acc #1 (blower). Acc .2 (light),
an electronic thermostat and 2 indicator lights
for SYSTEM and HEA TE R.
f'lEATER INDICATOR LIGHT
Indicates wtiefl me heater is ON regardless of
pump mode or whether the pump is being
operated manually, theJ'moSt8ticall'y or by the
time clock. When the heater light is ON. the
heater is ON, except if the Heater Reset
Indicator Light is OFF. (See Section 3.4.4.)
I L L. NO.6
-
3.4.2 TIME DELAY FUNCTION
A time delay is provided to keep the pump
running for 25 seconds after the heater is
turned OF F. This allows the heater element to
cool down before the water flow is StOpped.
SPA SIDE CONTROL
3.4.3 AUTOMATIC EQUIPMENT PROTECTION
This function is electronically built-in and
automatically turns Off all manually activated
equipment inctuding the "SVS" funCtion after
the system has been turned on for 30-45
minutes. This function protects your equip-
ment from running too long and saves on
electric bills.
SYSTEM BUTTON :
This button controls all 4 ON/OFF buttons.
When it is off. the system light is OFF and
none of the buttons will work.
It directly controls the low speed pump.
Whenever it is on, the pump will run continu-
ously, even if it is in the thermostat control
mode until turned OFF by the "-Automatic
Equipment Protection" function. (See Section
3.4.3) The System always resets off following
a power outage.
3.4.4 HEATER RESET INDICATOR LIGHT
This if1dieator light is located on top of the
heater housing, next to the Heater ReSet
Button. It is used in conjunction with the
"Heater IMieator Light" loCated on the Spa
Side Control (See 3.4.1) to trouble Sttoot
heater operation. {See Trouble Shooting
Guide in the back pocket of this manual for
further information.)
JET BUTTON:
Turns the pump from low to high speed and
back. For systems with 120 volt heaters, the
heater will turn OFF whenever this button is
pushed. On 240 volt -50A heated system, the
heater will not be affected.
3.4.5 TIME CLOCK
SETTING TIMER
a. Turn dial clockwise to correct time.
Turning dial counterclockwise wilt
damage timer switching mechanism and
void warranty.
ACCESSORY #1 BUTTON;
Turns blower ON and OFF. This function
interacts with heater the same way as the Jet
button.
7