Owner`s manual

PAGE 14
D. SETTING FILTRATION CYCLES
Filtration cycles have been preset at the
factory from 8 AM to 10 AM and from
4PM to 6 PM. They can be changed as
follows.
1. Press and hold the “PROG” button for
5 seconds to enter the programming
mode. “AH” will flash on the display. If
you are already in the programming
mode, go to the step 2 directly.
2. Press “PROG” three times to show
the filter cycle schedule. Notice the
flashing filter icon.
3. Press “UP” and “DOWN” to change
the hour.
4. Press “JET” button to change the filter
from “-” (Off) to “F” (ON) or vice versa.
5. Wait 30 seconds or press the “LIght”
button to exit the programming mode.
USI
NG YOUR SPA
A. DISPLAYING TIME OR
TEMPERATURE
Pressing the “PROG” button will switch
the display between current time and
current water temperature.
B. WATER JET THERAPY
Your spa is equipped with one or two
therapy pumps that can be activated as
follows.
Jet Button:
SINGLE PUMP SYSTEM:
1. Press “JET” to activate the Relaxation
Therapy mode.
2. Press “JET” to activate the Power
Therapy mode.
3. Press “JET” to turn pump off
programmed hours. (See “Setting
Filtration Hours”). Note that, if at the end
of filtration cycle the water is not at the
chosen temperature, the pump and
heater will not continue to run until that
temperature is reached. This mode is
used for energy conservation, the same
way you would control your heat or air
conditioning in your house. The clock
icon will be displayed when in
ECONOMY mode.
To switch to the ECONOMY mode:
1. Press and hold the “PROG” button for
5 seconds to enter the programming
mode. “AH” will flash on the display.
2. Press “UP” or “DOWN” button to
change between ECONOMY (ECO) and
AUTO HEAT (AH). Observe the clock
icon when in ECONOMY mode.
3. Wait 30 seconds or press “Light”
button to exit the programming mode.
C. SETTING CURRENT TIME
1. Press and hold the “PROG” button
for 5 seconds to enter the programming
mode. “AH” will flash on the display. If
you are already in the programming
mode, go to step 2 directly.
2. Press “PROG” one more time to
show the Hour.Observe the flashing clock
icon and PM indicator. No indicator
means AM.
3. Press “UP” or “DOWN” to select the
current hour.
4. Press “PROG” one more time to
show the minutes.
5. Press “UP” or “DOWN” to select the
current minute.
6. Wait 30 seconds or press the “Light”
button to exit the programming mode.