Replacement Part List

Base Molding

ASS EM BLY IN STR UCTION S

Please read through be for e s ta rting installation .

Check Box for These Content s

In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346 (Mon. to Fri. 8:00 AM to 5:00 PM EST).

V1.3/091020

BP81000 - Pergola Base Molding- Tall

VA81011 - Composite Pergola Base Molding - Tall

BP81001 - Pergola Base Molding- Short

VA81012 - Composite Pergola Base Molding - Short

BP80000 - 5” x 5” Arbor Trim Kit

op Trim Cap (4)

White #10764 Composite #14055

Tall Extrusion (4)

White #10175-1 Composite #14092 - 6” x 6” x 36”

(15 cm x 15 cm x 91 cm)

Bottom Trim (4)

White #10765 Composite #14057

Vinyl Glue (1) -

White #20000 Composite #20022

Pergola Base Molding - Tall

op Trim Cap (4)

White #10764 Composite #14055

Short Extrusion (4)

White #10173-1 Composite #14056 - 6” x 6” x 8”

(15 cm x 15 cm x 20 cm)

Bottom Trim (4)

White #10765 Composite #14057

Vinyl Glue (1) -

White #20000 Composite #20022

Pergola Base Molding - Short

(4)

Bottom Trim (4)

(4)

(1) -

5” x 5” Arbor Trim Kit

www.wearevita.com

PAGE 1
A S S E M B LY I N S T R U C T I O N S Base Molding www.wearevita.com BP81001 - Pergola Base Molding- Short VA81012 - Composite Pergola Base Molding - Short BP81000 - Pergola Base Molding- Tall VA81011 - Composite Pergola Base Molding - Tall BP80000 - 5” x 5” Arbor Trim Kit Please read through befor e sta rting installation . Check Box for Th ese Content s In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346 (Mon. to Fri. 8:00 AM to 5:00 PM EST).
PAGE 2
STEPS 1 1 Using the glue provided, run a small bead around the inside of the base molding extrusion. 2 Carefully place the bottom trim on one end of the base molding extrusion. 3 Run another bead of glue on the other (inside) end of the base molding extrusion. 4 Carefully place the top trim cap on the base molding extrusion. 5 2 Repeat for all base moldings. Note: Please allow the glue to set for 15 minutes prior to installing the base molding on the pergola/arbor.
PAGE 3
STEPS www.wearevita.com On the Bottom Trims, there is a notch alongside the inside face. this is designed to clear screw heads during installation: 1 Typically your post would be fastened to a wooden post as shown. 1 2 3 2 The base molding then can slide down and clear the screw heads. 3 To make sure the base molding clears the screw heads, the screws fastening the post to the wooden post should be well within a 1½ in (4 cm) radius of the center of the post.